Filter
Top Products
66
used for SNMP v1 and SNMP v2.
Example 1: Set the secure IP address to 1.1.1.5
Switch(config)#snmp-server securityip 1.1.1.5
Example 2: Delete the secure IP address
Switch(config)#no snmp-server securityip 1.1.1.5
2.4.4.2.10 snmp-server SecurityIP enable
Command: snmp-server SecurityIP enable
snmp-server SecurityIP disable
Function: Enable or disable secure IP address check function on the NMS.
Command mode: Global Mode
Default: Secure IP address check function is enabled by default.
Example: Disable secure IP address check function.
Switch(config)#snmp-server securityip disable
2.4.4.2.11 rmon enable
Command: rmon enable
no rmon enable
Function: Enable RMON; the “no rmon enable” command disables RMON.
Command mode: Global Mode
Default: RMON is disabled by default.
Example 1: Enable RMON
Switch(config)#rmon enable
Example 2: Disable RMON
Switch(config)#no rmon enable
2.4.5 Typical SNMP Configuration Examples
The IP address of the NMS is 1.1.1.5; the IP address of the switch (Agent) is 1.1.1.9
Scenario 1: The NMS network administrative software uses SNMP protocol to obtain data
from the switch.
The configuration on the switch is listed below:
Switch(config)#snmp-server