Filter
Top Products
374
z router rip
z timer basic
z version
z show ip protocols
z show ip rip
z debug ip rip packet
z debug ip rip recv
z debug ip rip send
15.3.2.2.1 auto-summary
Command: auto-summary
no auto-summary
Function: Configure route aggregation; the “no auto-summary” command disables
route aggregation.
Parameter: N/A.
Default: Auto route aggregation is not used by default.
Command mode: RIP configuration mode
Usage Guide: Route aggregation reduces the amount of routing information in the route
table and amount of information to be exchanged. RIP-I does not support subnet mask,
forwarding subnet route may result in ambiguity. For this reason, route aggregation is
always enabled for RIP-I. If you are using RIP-II, you can use “no auto-summary”
command to disable route aggregation. If subnet route needs to be broadcasted, route
aggregation can also be disabled.
Example: Set the RIP version to RIP-II and disables route aggregation.
Switch(Config)#router rip
Switch(Config-Router-Rip)#version 2
Switch(Config-Router-Rip)#no auto-summary
Related command: version
15.3.2.2.2 default-metric
Command: default-metric <value>
no default-metric
Function: Set the default route metric for route to be introduced; the “no default-metric”
command restores the default setting.
Parameter: < value> is the value of route metric, ranging from 1 to 16.
Default: The default route metric is 1.
Command mode: RIP configuration mode
Usage Guide: “default-metric” command sets the default route metric used in