Filter
Top Products
521
Usage Guide: This command is used to configure the commander switch remotely. Users
have to telnet the commander switch by passing the authentication. The
command “exit” is used to quit the configuration interface of the commander
switch. If this command is executed in the commander switch, an error will be
displayed.
Example: In the member switch, enter the configuration interface of the commander
switch.
Switch#rcommand commander
18.2.2.9 cluster reset member
Command: cluster reset member <mem-id>
Function: In the commander switch, this command can be used to reset the member
switch.
Parameter: <mem-id> is the cluster ID of the member switch, valid rang is 1 to 23.
Command mode: Admin Mode
Usage Guide: In the commander switch, users can use this command to reset a member
switch. If this command is executed in a non-commander switch, an error will be
displayed.
Example: In the commander switch, reset the member switch 16.
Switch#cluster reset member 16
18.2.2.10 cluster update member
Command: cluster update member <mem-id> <src-url> <dst-url> [ascii | binary]
Function: In the commander switch, this command is used to remotely upgrade the
member switch.
Parameter: <mem-id> is the cluster ID of the member switch, valid rang is 1 to 23;
<src-url> is the source path of the file which need to be copied; <dst-url> is the
destination path of the file which need to be copied; ascii means that the file is transmitted
in ASCII format; binary means that the file is transmitted in binary. When <src-url> is a
FTP address, its format is like: ftp: //<username>: <password>@<ipadress>/<filename
>.
<username> is the FTP user name, <password> is the FTP password, <ipadress> is the
IP address of the FTP server and <filename> is the file name. When <src-url> is a TFTP
address, its format is like: tftp: //<ipadress>/<filename>. <ipadress> is the IP address of
the TFTP server and <filename> is the file name.
The special keywords of filename: