Filter
Top Products
345
value 30 first and policed DSCP 1/2 for value10/20, selecting Set for Operation type, then
click Apply.
13.2 PBR
This chapter describes how to configure the PBR through the examples.
13.2.1 PBR Introduction
The PBR (Policy-Based Routing) allows modifying the next hop of the packets
according to IP source address, IP destination address, IP precedence, ToS, IP protocol,
source port number and destination port number etc.
13.2.2 PBR Configuration
13.2.2.1 PBR Configuration Step
1． Enable the PBR
When the QoS is enabled and disabled globally, the PBR is enabled and disabled
automatically.
2． Configure the class-map
Create a classification policy in order to use different policies for different traffic.
3． Configure the policy-map
Create the policy-map. Then correspond the policy-map to the class-map. Enter the
policy-map mode and set the next hops for different traffic.
4． Apply the policy to the port.