Filter
Top Products
1152700 • Issue 1 • February 2001 • Section 2 Operation and Maintenance
Page 2-103
2000, ADC Telecommunications, Inc.
DLP-712
Page 5 of 8
Cellworx Vision: Error
Validation failed. Unable to determine card type
for slot 8 in the new EPS NE. It is possible that the
shelf controller has not yet had enough time to discover
the cards in the shelf. You may retry or cancel this
procedure. Note that if you cancel, you will need to
reboot the EPS shelf controller(s) before attempting
to re-add this EPS.
X
OK
0026-055
Figure 712-5. Add EPS NE Error Message
Cellworx Vision: Add EPS NE - Connect to Ring
X
Physically connect the expansion network
element to the ring network element.
Cancel
Next >>
10889-A
Figure 712-6. Cellworx Vision Add EPS NE - Connect to Ring
Cellworx Vision: Add EPS NE - Wait for Bootup
X
Waiting for expansion node to boot...
Cancel
Normal boot time should not exceed 5 minutes.
Elapsed time: 9
10895-B
Figure 712-7. Cellworx Vision Add EPS NE - Wait for Bootup
Cellworx Vision: Add EPS NE - Boot Time Exceeded
Normal boot time for the network element has
been exceeded. This could be the result of a
communication failure with the network element.
Please check all cables and the network element's
status via craft interface if necessary.
Retry
X
Quit
10888-A
Figure 712-8. Add NE Boot Time Exceeded Window