Filter
Top Products
1152700 • Issue 1 • February 2001 • Section 2 Operation and Maintenance
Page 2-246
© 2000, ADC Telecommunications, Inc.
DLP-754
Page 2 of 7
10. Set the rest of the DS1 Channel Level configuration options per requirements. Refer to
Table 754-2 for a list of options the user may select.
11. Select the Apply button after configuring the channel.
12. Double click on the DS3 port on the faceplate to bring up the Interface type screen. If CRS
was selected, the screen shown in Figure 754-3 will appear. If CES service type was
selected, the screen shown in Figure 754-4 will appear. Select the configuration for the
Service type on the port using Table-754-3 as a reference for CRS mode or Table 754-4 for
CES mode.
13. Select the Apply button followed by the Close button to return to the card view screen.
14. Repeat steps 8 through 14 for each channel on the T3 port.
15. Select the Close button on the DS1 Channel window and the T3 TMUX Multi 1 window
using the left mouse button once all channels have been configured.
16. Repeat steps 1 through 16 for each T3 TMUX Multi 1 card installed in the shelf.
Stop! You have completed this procedure.
Cellworx Vision: Card View - T3 TMUX Multi 1 Mother Card
Status:
Apply Chassis View
Refresh Close
X
Configuration:
Card Level
Congestion Thresholds:
Ingress:
Egress:
80
80
%
%
Port Level
Administrative State: Transmit Timing Source:
Locked
Unlocked
Recieved
Local
Line Build Out (LBO):
NE Name: Cellworx1
NE Id: 1
Card: T3 TMUX MULTI 1 / TMUX E
Slot Number: 9
Port Number: 1
Circuit Identifier: default
Line Type:
Line Coding: B3ZS
0-150 feet
150-450 feet
Loopback Config:
Status
Active
Protect
1
Port
ADC
T3 TMUX
MULTI 1
Status
Active
Protect
ADC
TMUX
EXP
Slot: 3 Slot: 4
Locked
Unlocked
M23
C-bit Parity
CLICK ON BOX AND DRAG
UP OR DOWN TO WIDEN
STATUS OR CONFIGURATION
VIEWS.
Administrative State:
CLICK ON BOX AND DRAG UP
OR DOWN TO WIDEN PORT
LEVEL VIEW.
USE SLIDERS TO VIEW
HIDDEN SELECTIONS.
APPLIES CHANGES
AND SENDS TO SHELF
CONTROLLER.
RETURNS TO CHASSIS
VIEW WITHOUT CLOSING
CARD LEVEL VIEW.
REPAINTS WINDOW
TO REFLECT ANY
CHANGES.
CLOSES CARD LEVEL
VIEW AND RETURNS TO
SHELF LEVEL VIEW.
NE AND CARD TYPE/
SLOT INFORMATION.
CARD REPRESENTATION
WITH REAL TIME ALARM
INDICATIONS.
DS3 PORT LEVEL
CONFIGURATION OPTIONS.
CARD LEVEL
CONFIGURATION OPTIONS.
13435-B
DS3 Port
DS1 Channel
None
Facility Payload
Facility Line
Terminal
Far End Loopback:
None
Channel Number:
SELECT DS1 CHANNEL
DOUBLE-CLICK TO BRING
UP ATM INTERFACE
SCREEN AFTER SELECTING
THE DS1 CHANNEL TAB.
Figure 754-1. T3 TMUX Multi 1 Card Configuration Window