Filter
Top Products
ADCP-70-220 •Issue 1 • November 2000 • Section 2 Operation and Maintenance
Page 2-25
© 2000, ADC Telecommunications, Inc.
NTP-010
Page 1 of 1
DELETE A CELLWORX STN NODE
Summary: This procedure outlines the steps involved to remove a Cellworx STN ring node from
an in-service ring network, or an expansion shelf from an in-service condition. This procedure
enables the network administer to change the network configuration when required. It may be
necessary to remove a ring NE via software if the network is being uninstalled, or the equipment
at a site is being moved to a new location, etc. Before removing a node from the network, all
VP/VC connections to that node must be deleted.
DELETE A RING NODE FROM AN IN-SERVICE RING SYSTEM
1. Launch the Cellworx Vision Graphical User Interface (GUI). DLP-705
2. Delete any VP/VC connections that are terminated at the node
being removed from service. DLP-739
3. Delete the node via the GUI using one of the following
procedures according to the type of node being removed:
• Delete a Cellworx STN node. DLP-740
• Delete a Cellworx STN EPS shelf. DLP-746
Stop! You have completed this procedure.