Filter
Top Products
ADCP-70-220 • Issue 1 • November 2000 • Section 2 Operation and Maintenance
Page 2-12
© 2000, ADC Telecommunications, Inc.
NTP-005
Page 1 of 2
TURN UP (PROVISION) CELLWORX STN EXPANSION SHELVES
Summary: This procedure describes the steps required to add a Cellworx STN expansion shelf
(STN-EPS) to an in-service ring node or one that has just completed the initial discovery
process.
Note: Applications using the 19-inch chassis will show card slots 1 through 18 but only
card slots 1 through 11 and 16 through 18 are programmable.
Prerequisites to this procedure are:
• Ring node must be in-service and fibers correctly installed to the expansion shelf.
• Shelf ExPansion Interface Cards (SEPICs) cards must be installed and in-service in the
ring node.
• Shelf ExPansion Interface Cards (SEPICs) must be installed in the expansion shelf.
• Expansion shelf must have shelf type set to 03 for expansion NE. This is accomplished
by the thumbwheel switch on SC TEIM in slot 18 at the rear of the shelf and should have
been set during shelf installation procedures. If shelf type is changed, SC card must be
reset using the button under the front hinged faceplate. Refer to the Installation Manual
1152693.
1. Ensure there is not a Level 1 GUI user logged onto the system.
If necessary, force the user session off using the following
procedure: DLP-778
2. Launch the Cellworx Vision GUI from the X-Terminal. DLP-705
3. Double click on the icon representing the ring node that will
have the expansion shelf (STN-EPS) added to it. This will open
a shelf level GUI window for the node.
4. Verify that the expansion shelf interfaces in the ring node are
equipped and in-service. To do this, double click on each
simulated interface card shown on the shelf level GUI display.
Equipped, in-service cards should have a green status indication
at the bottom of the faceplate on the display.
5. If the expansion shelf interface cards are not installed, refer to
the Cellworx STN Installation Manual for card installation
procedures. 1152693
6. Verify the cards are configured as Shelf Expansion Interfaces
for either of the following:
155 SM/MM CRS cards DLP-752
622 SM CRS cards DLP-797
T3 CRS cards DLP-753