Filter
Top Products
1152700 • Issue 1 • February 2001 • Section 2 Operation and Maintenance
Page 2-193
2000, ADC Telecommunications, Inc.
DLP-738
Page 2 of 7
8. Next the Cellworx Vision software configuration window appears for the new NE, and the
Task Overview pointer moves to step 5. Refer to Figure 738-9. At this point the SC card(s)
should show a running software image but the RICs will be blank. Follow the instructions
at the top of the window to select a software image for the RICs and then hit Apply.
9. The Download Status column changes to Loading for both of the RIC cards. This process
will take up to four minutes. During this process the user may select the Refresh button to
update the display.
Note: If the screen is refreshed during the RIC software download, the Download Status
column will change to None. This is OK. The RICs will continue to boot. Once
completed with the boot process, the user must select Refresh again to update the
Running Software Version column.
10. Upon completion of the software download to both RICs, and the user selecting Refresh,
both RICs will have a running software version displayed and the Skip button at the bottom
of the screen is changed to a Continue button.
11. Select the Continue button. The system now attempts to discover the new NEs, indicated
by the pointer on step 9 of the Task Overview window, and the “Discovering Network”
message window as shown in Figure 738-10. If a problem is encountered during discovery,
the message window shown in Figure 737-11 will appear instructing the user to check fiber
connections. The user may then retry the discovery or abort the entire process. See Section
4 of this manual for troubleshooting tips if problems are encountered with the boot up
process. A discovery verifies the physical connectivity between the nodes and should take
less than ten seconds.
12. The system responds with a message window indicating that it is updating the network
topology and to please wait. Refer to Figure 738-12.
13. The user will be prompted to save the new icon layout. Refer to Figure 738-13. To do this,
select the disk icon on the tool bar above the work area or select the File pull down menu
and Save Icon Layout or by entering Alt+F followed by an Alt+S on the keyboard. Refer to
Figure 738-14.
Stop! You have completed this procedure.