Filter
Top Products
1152700 • Issue 1 • February 2001 • Section 2 Operation and Maintenance
Page 2-416
© 2000, ADC Telecommunications, Inc.
DLP-792
Page 4 of 4
Table 792-2. T3 CES Interface Configuration Options
SELECTION DEFAULT OPTIONS DEFINITIONS
Interface Name User Defined Can be used to assign a name to the port or use
the system default.
ATM VPI <user
defined>
0-8 This is a read only to show the available bits
configured for this port during connection
creation.
ATM VCI <user
defined>
0-10 This is a read only to show the available bits
configured for this port during connection
creation.
Operational State Up Up
Down
Unknown
Display only. State of the interface port is Up
and available for service, Down due to a
problem, or Unknown due to communication
error.
Buffer Maximum Size 1600 1500 to 2000 Maximum size measured in microseconds and
selectable in 10 microsecond increments.
Cell Arrival Jitter
Tolerance
800 750 to 1000 Maximum size measured in microseconds and
selectable in 10 microsecond increments.
CBR Clock Mode Adaptive Adaptive
Synchronous
SRTS
Sets the Constant Bit Rate clock to adapt to the
incoming bit stream, look for a constant
synchronous bit stream, or Synchronous Residual
Time Stamp used for recovering clock signals in
a packet system (ATM).