Filter
Top Products
Configuring Bridging and Routing Sessions
228 Avidia System Configuration and Management User Manual
CONFIGURING BRIDGING AND ROUTING SESSIONS
You can configure bridging and routing sessions using PVCs that terminate on the management
card (for example, PVCs between ADSL cards and the management card or PVCs between OC3
line cards and the management card). You can configure 96 bridging and routing sessions.
To configure a bridging or routing session, you configure a PVC between a line or channel card
and the management card, then set up the desired service for the session (bridging, routing or
both). The system automatically assigns the management card VPI and VCI for each session. If
you are configuring a session using a frame-based card, the system automatically assigns the
VPI and VCI and configures the session to use VC-MUX_Bridged encapsulation mode.
You configure sessions using the command-line interface from the ::session=> prompt.
From the ::root=> prompt, type the following command then press to display the
::session=> prompt.
configuration atm session
Adding Sessions
From the ::session=> prompt, type the new command in the following format then press
.
new <slot.port> <vpi|*> <vci|*><(llc-snap|vcmuxbr|vcmuxrt)>
[-dlci <dlci>] [-subs <subscriber>] [-service
(bridge|{{route|broute} -ipaddr <ipaddr> -mask <ipmask>})]
[-stppri <priority>] [-stpcost <cost>][-admin (up|down)]
Parameters
<slot.port>
The line or channel card slot and port you want to use for this PVC.
<vpi|*>
The VPI you want to use for this PVC. Type * if you are using an SDSL channel card for
the PVC, as the system automatically assigns the VPI in this case.
<vci|*>
The VCI you want to use for this PVC. Type * if you are using an SDSL channel card for
the PVC, as the system automatically assigns the VCI in this case.
ENTER
ENTER