Filter
Top Products
Chapter 22: Configuring ATM Virtual Circuits
Avidia System Configuration and Management User Manual 455
Click and if necessary to view the entire table. displays the beginning of the table.
displays the next page of the table. The SPVC Configuration table displays the following
information for each SPVC.
Information Description
Admin Status The SPVC administrative status. Options:
• Up—activated
• Down—deactivated
Oper Status The SPVC operational status. Options:
• In Progress—attempting to connect
• Connected—operational
• Retries Exhausted—not operational
Source Slot The channel card slot number.
Source VPI The VPI of the PVCC between the CPE and the line card.
Source VCI The VCI of the PVCC between the CPE and the line card.
Source Encap The PVCC encapsulation type (applies to frame channel cards
only). Options:
• LLC_8023
• VC_MUX_8023
Destination Address The ATM address of the destination ATM end system.
Destination Retry Interval The number of seconds the system waits before attempting
to re-establish the SPVC after a failed call attempt (range: 0 to
3600).
Destination Retry Limit The maximum allowable number of unsuccessful call setup
attempts (range: 0 to 65535).
Last Rel. Cause The reason the SPVC was last disabled. This displays as a
numeric code. See “SPVC Last Release Cause Codes” on
page 607 for code definitions.
Tx Idx The traffic descriptor profile index assigned to the SPVC
transmitted traffic.
Rx Idx The traffic descriptor profile index assigned to the SPVC
received traffic.