Filter
Top Products
Configuring and Initiating OAM Loopbacks
560 Avidia System Configuration and Management User Manual
From the OAM Loopback Table, set the Source Location ID for the Avidia system. This is
important, as it enables the Avidia system to determine whether or not it is the originator of
received loopback cells. The Source Location ID default is
ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff. Set a unique ID prior to initiating a loopback, as other
devices involved in the loopback could default to the same Location ID (see “ATM Device
Addresses” on page 23 for more information about Locations IDs). It is recommended that
the OAM Source Location ID address for the Avidia system is set up with:
• a unique address that is meaningful to you for the first 13 octets
• all zeros for the last three octets
1 In the
OAM Loopback Table window, click Set to display the Set Source Location ID window.
2 In the Source Location ID box, type the OAM Location ID (format xx:xx:xx:xx:xx:xx:xx:
xx:xx:xx:xx:xx:xx:xx:xx:xx where x is an integer 0 - 9 or an alpha character a - f).
It is recommended to use 13-octet network prefix for the Avidia system followed by
00:00:00 for the Source Location ID.
3 Do one of the following:
• Click
Get to cancel the new address. You can only cancel the new address if you have
not clicked
Set.
• Click
Set to save the new address.