Filter
Top Products
4-5
ATM Switch Router Software Configuration Guide
OL-7396-01
Chapter 4 Configuring System Management Functions
System Management Tasks
Configuring Login Authentication
To enable TACACS+ authentication for logins, perform the following steps, beginning in global
configuration mode:
logging monitor level Limits messages logged to the terminal lines
(monitors) based on severity, use the logging monitor
global configuration command. This command limits
the logging messages displayed on terminal lines other
than the console line to messages with a level at or
above level. The no logging monitor command
disables logging to terminal lines other than the
console line.
logging on Controls logging of error messages, use the logging on
global configuration command. This command enables
or disables message logging to all destinations except
the console terminal. The no logging on command
enables logging to the console terminal only.
logging trap level Limits messages logged to the syslog servers based on
severity, use the logging trap global configuration
command. The command limits the logging of error
messages sent to syslog servers to only those messages
at the specified level. The no logging trap command
disables logging to syslog servers.
logging source-interface type
identifier
Specifies the interface for source address in logging
transactions.
Command Purpose
Command Purpose
line [aux | console | vty] line-number
[ending-line-number]
Selects the line to configure.
login [local | tacacs] Configures login authentication.