13-14
ATM Switch Router Software Configuration Guide
OL-7396-01
Chapter 13 Configuring IP over ATM
Configuring IP Load Sharing
Note This feature is only available for Gigabit Ethernet line cards.
Note This feature should only be used with switches equipped with Enhanced ATM Router Modules. This
command cannot be used with switches equipped with standard ATM Router Modules.
Note Per packet load balancing should not be configured on MPLS-enabled interfaces.
Example
The following example enables load-sharing for all IP packets on ethernet interface 0:
Switch# configure terminal
Switch(config)# interface ethernet 0
Switch(config-if)# ip load-sharing per-packet
Switch(config-if)# exit
Switch(config)# epc xpif-ip-per-pack-all
Step 2
Switch(config-if)# exit Exits interface configuration mode.
Step 3
Switch(config)# epc xpif-ip-per-pack-all Enables per packet load sharing for all IP traffic
for interface enabled with the ip load-sharing
per-packet enable command.
Command Purpose