Filter
Top Products
26-6
ATM Switch Router Software Configuration Guide
OL-7396-01
Chapter 26 Managing Configuration Files, System Images, and Functional Images
Maintaining Functional Images (Catalyst 8540 MSR)
To download a functional image from a Flash memory device to a hardware controller, use the following
command in privileged EXEC mode:
The reprogram command checks the compatibility of the image for the selected card type before
downloading the functional image. If you have specified a slot number without a subcard, the functional
image is downloaded to the full-width module that occupies that slot.
Note After loading a new functional image on the primary route processor or on one of the switch processors,
you must power-cycle the switch for the hardware to reconfigure itself with the new image.
Caution Do not interrupt the download procedure. Wait until it has finished before attempting any commands on
the switch.
Example
The following example demonstrates loading the functional image fi_c8540_rp.B.3_91 from the
Flash PC card in slot 0 to the controller for the route processor in slot 4.
Switch# reprogram slot0:fi_c8540_rp.B.3_91 4
Displaying the Functional Image Information (Catalyst 8540 MSR)
To display the functional image version in a hardware controller, use the following command in
privileged EXEC mode:
Example
The following example shows the functional image information in the controller for the route processor
module in slot 4:
Switch# show functional-image-info slot 4
Details for cpu Image on slot: 4
Functional Version of the FPGA Image: 4.8
#Jtag-Distribution-Format-B
#HardwareRequired: 100(3.0-19,4.0-19,5.0-19)
#FunctionalVersion: 4.8
#Sections: 1
#Section1Format: MOTOROLA_EXORMAX
Copyright (c) 1996-00 by cisco Systems, Inc.
Command Purpose
reprogram device:filename {slot [subcard] |
rommon}
Loads the functional image with the specified
filename to a device.
Command Purpose
show functional-image-info {slot slot |
subslot slot/subslot}
Displays the functional image information.