Filter
Top Products
7-67
ATM Switch Router Software Configuration Guide
OL-7396-01
Chapter 7 Configuring Virtual Connections
Configuring Point-to-Multipoint Soft PVC Connections
Step 6 Use the following similar process to configure the Soft PVC connection to the Dest_Two switch:
Source(atmsoft-p2mp)# party leaf-reference 2
Source(atmsoft-p2mp-party)# dest-address
47.0091.8100.0000.00e0.4fac.b401.4000.0c80.9030.00 50 120
Source(atmsoft-p2mp-party)# end
Source#
Step 7 Finally, confirm the connections are up and working using the commands in the section, “Displaying
Point-to-Multipoint Soft PVC Configuration” section on page 7-67.
Displaying Point-to-Multipoint Soft PVC Configuration
To display the point-to-multipoint soft PVC configuration at either end of an ATM switch router, use the
following EXEC commands:
Examples
The following example shows the point-to-multipoint soft PVC configuration of Source, on interface
ATM 0/0/2 out to the ATM network:
Source# show atm soft-vc p2mp interface atm 0/0/1 50 100
Interface: ATM0/0/1, Type: oc3suni
VPI = 50 VCI = 100
Connection-type: SoftVC
Cast-type: point-to-multipoint-root
Soft vc location: Source
Soft vc call state: Inactive
Leaf-ref VPI VCI NSAP Address State
1 50 110 47.0091.8100.0000.0090.2156.d801.4000.0c80.1010.00 Inactive
2 50 120 47.0091.8100.0000.00e0.4fac.b401.4000.0c80.9030.00 Inactive
Source#
Command Purpose
show atm soft-vc p2mp interface atm
card/subcard/port vpi vci
Shows point-to-multipoint soft PVC interface
configuration.
show atm vc interface atm card/subcard/port Shows the VCs configured on the ATM interface.