Filter
Top Products
19-62
ATM Switch Router Software Configuration Guide
OL-7396-01
Chapter19 Configuring Circuit Emulation Services
Configuring Explicit Paths on CES VCs
Configuring CES VC Explicit Paths
To configure CES VC explicit paths, follow these steps, beginning in global configuration mode:
Command Purpose
Step 1
Switch(config)# interface cbr card/subcard/port
Switch(config-if)#
Selects the physical interface to configure.
Step 2
Switch(config-if)# ces circuit circuit-id [cas]
[cdv max-req] [circuit-name name]
[partial-fill number] [shutdown]
[timeslots number]
[on-hook-detect pattern]
Configures the following CES connection
attributes for the circuit:
• Circuit ID number.
–
For unstructured service, use 0.
–
For CES T1 structured service,
use 1 through 24.
–
For CES E1 structured service,
use 1 through 31.
• Enables channel-associated signaling for
structured service only. The default is no
channel-associated signaling.
• Enables the peak-to-peak cell delay variation
requirement. The default is
2000 milliseconds.
Step 3
Switch(config-if)# ces pvc circuit-id
dest-address atm-address [[vpi vpi-number]
vci vci-number] [follow-ifstate] [retry-interval
[first retry-interval] [maximum retry-interval]]
redo-explicit [explicit-path precedence
{name path-name | identifier path-id}
[upto partial-entry-index]] [only-explicit]
or
ces svc circuit-id dest-address atm-address
[hold-priority priority] [follow-if-state]
[retry-interval [first retry-interval]
[maximum retry-interval]] redo-explicit
[explicit-path precedence {name path-name |
identifier path-id} [upto partial-entry-index]]
[only-explicit]
Configures a CES soft PVC or CES SVC
(switched VC) explicit path connection.
Step 4
Switch(config-if)# end
Switch#
Exits interface configuration mode.