Filter
Top Products
8-3
ATM Switch Router Software Configuration Guide
OL-7396-01
Chapter 8 Configuring Operation, Administration, and Maintenance
Configuring OAM Functions
Configuring OAM Functions
This section describes OAM commands in EXEC, global, and interface configuration mode.
Configuring OAM for the Entire Switch (Catalyst 8540 MSR)
To enable OAM operations for the Catalyst 8540 MSR, use the global configuration command, as shown
in the following table:
Note The number of maximum OAM configured connections allowed ranges from 1 to 3200; the default
is 3200.
Examples
The following example shows how to enable AIS and segment loopback for the entire switch:
Switch(config)# atm oam ais seg-loopback
% OAM: Switch level seg loopback is enabled
% OAM: Switch level ais is enabled
The following example shows how to configure the ATM OAM connection maximum to 1600:
Switch(config)# atm oam max-limit 1600
Configuring OAM for the Entire Switch (Catalyst 8510 MSR and
LightStream 1010)
To enable OAM operations for the entire Catalyst 8510 MSR and LightStream 1010 ATM switch router,
use the global configuration command, as shown in the following table:
Note The number of maximum OAM configured connections allowed ranges from 1 to 3200; the default
is 3200.
Examples
The following example shows how to enable AIS and segment loopback for the entire switch:
Command Purpose
atm oam [ais] [end-loopback]
[max-limit number] [rdi] [seg-loopback]
Enables or disables OAM operations for the
entire switch.
Command Purpose
atm oam [ais] [end-loopback]
[intercept end-to-end] [max-limit number]
[rdi] [seg-loopback]
Enables or disables OAM operations for the
entire switch.