Filter
Top Products
11-42
ATM Switch Router Software Configuration Guide
OL-7396-01
Chapter 11 Configuring ATM Routing and PNNI
Advanced PNNI Configuration
Example
The following example shows the ATM PNNI transit-restriction configuration using the show atm pnni
local-node privileged EXEC command:
Switch# show atm pnni local-node
PNNI node 1 is enabled and running
Node name: Switch
System address 47.00918100000000400B0A3081.00400B0A3081.00
Node ID 56:160:47.00918100000000400B0A3081.00400B0A3081.00
Peer group ID 56:47.0091.8100.0000.0000.0000.0000
Level 56, Priority 0, No. of interfaces 4, No. of neighbors 2
Node Does Not Allow Transit Calls
Hello interval 15 sec, inactivity factor 5,
Hello hold-down 10 tenths of sec
Ack-delay 10 tenths of sec, retransmit interval 5 sec,
Resource poll interval 5 sec
PTSE refresh interval 1800 sec, lifetime factor 200 percent,
Min PTSE interval 10 tenths of sec
Auto summarization: on, Supported PNNI versions: newest 1, oldest 1
Default administrative weight mode: uniform
Max admin weight percentage: -1
Next resource poll in 3 seconds
Max PTSEs requested per PTSE request packet: 32
Redistributing static routes: Yes
Configuring Redistribution
Redistribution instructs PNNI to distribute reachability information from non-PNNI sources throughout
the PNNI routing domain. The ATM switch router supports redistribution of static routes, such as those
configured on Interim Interswitch Signaling Protocol (IISP) interfaces.
Note By default, redistribution of static routes is enabled.
To enable redistribution of static routes, perform these steps, beginning in global configuration mode:
Command Purpose
show atm pnni local-node Displays the ATM configuration.
Command Purpose
Step 1
Switch(config)# atm router pnni
Switch(config-atm-router)#
Enters ATM router PNNI mode.
Step 2
Switch(config-atm-router)# node node-index
Switch(config-pnni-node)#
Enters node configuration mode.
Step 3
Switch(config-pnni-node)# redistribute
atm-static
Enables redistribution of static routes.