14-31
ATM Switch Router Software Configuration Guide
OL-7396-01
Chapter 14 Configuring LAN Emulation
LANE Configuration Examples
Default Configuration for a Token Ring ELAN with IP Source Routing
(Catalyst 8510 MSR and LightStream 1010)
The following example shows how to configure a single emulated Token Ring LAN using a Cisco 4500
router and an ATM switch with IP source routing across a source-route bridged network. In this example,
the emulated Token Ring LAN is source-route bridged to two physical Token Rings.
The router contains the LECS, LES, BUS, and an LEC. Both the ATM switch and Token Ring switch
contain an LEC for the emulated LAN. This example uses all LANE default settings. For example, it
does not explicitly set ATM addresses for the different LANE components that are colocated on the
router. Membership in this emulated LAN is not restricted (see Figure 14-5).
Figure 14-5 Single Emulated Token Ring LAN with Token Ring Switch
Router
router# show lane default-atm-addresses
interface ATM0:
LANE Client: 47.00918100000000603E7B2001.00000C407572.**
LANE Server: 47.00918100000000603E7B2001.00000C407573.**
LANE Bus: 47.00918100000000603E7B2001.00000C407574.**
LANE Config Server: 47.00918100000000603E7B2001.00000C407575.00
note: ** is the subinterface number byte in hex
Router
Router
LECS,
LES/BUS
LEC
atm 3/0.1
172.16.0.1
atm 0.2
172.16.0.3
atm 2/0/0.1
172.16.0.4
172.16.0.0
Token Ring switch
LEC
ATM switch
LEC
14212
Token
Ring
Token
Ring
Catalyst
3900