Filter
Top Products
19-60
ATM Switch Router Software Configuration Guide
OL-7396-01
Chapter19 Configuring Circuit Emulation Services
Configuring SGCP
CBR1.1.0/24 1 active b234abc
Displaying SGCP Connections
To display SGCP connections (either globally or per single interface), use the following EXEC
command:
Example
The following example displays all SGCP connections created on the ATM switch router:
Switch> show sgcp connection
Conn Endpt Soft VC State Call Id
CBR0.0.0/1 Dest- active VC d234ab
CBR0.0.0/2 Dest- active VC 12345bc
CBR0.0.0/3 Dest- active VC 1284ab
CBR0.0.0/4 Dest- active VC 9234abc
Configuring SGCP Request Handling
When the ATM switch router initiates an SGCP request (for example, to disconnect the circuit), default
request timer and request retry values are in operation. To change the default value of SGCP requests,
use the global configuration commands, as shown in the following table:
Examples
The following example shows how to change the request timeout to 2000 milliseconds:
Switch(config)# sgcp request timeout 2000
The following example shows how to change the request retry value to 5:
Switch(config)# sgcp request retries 5
Configuring Call-Agent Address
By default the SGCP call agents perform the following tasks:
• The ATM switch router sends a response to an SGCP request in a UDP packet with the destination
address the same as the source address of the request UDP packet.
Command Purpose
show sgcp connection [interface cbr
card/subcard/port]
Displays the SGCP connections.
Command Purpose
sgcp request timeout msecs Configures the SGCP request timeout value.
sgcp request retries number Configures the SGCP request retry value.