Filter
Top Products
11-64
ATM Switch Router Software Configuration Guide
OL-7396-01
Chapter 11 Configuring ATM Routing and PNNI
PNNI Connection Trace
Displaying PNNI Connection Trace Configuration
This section describes how to display active PNNI connection trace configuration.
To display the active PNNI connection trace configuration, use the following command:
Example
The following example shows an active PNNI connection trace configuration:
Switch_10# show atm pnni trace information
Max TTL Size: 1466 bytes
Accepted Requests: 1 ActiveRequests: 0
Max Acceptable Requests: 100 Max Concurrent Requests: 5
Boundary Interfaces:
None
Switch_10#
Note The Accepted Requests field should indicate a number less than the maximum of 100 connections.
Note The Active Requests field should indicate some number less than the maximum concurrent requests of 5.
Note Trace records for both switched and soft-VC calls are deleted automatically when that call is cleared. If,
for any reason, a soft VC is torn down, all existing trace records configured for that soft VC are deleted.
These records are deleted irrespective of the age-timer value. This deletion occurs even if the connection
is reconfigured again.
Deleting Connection Trace Requests
This section describes how to remove a connection trace request and its results. The system can
accommodate only100 trace connection records. When this limit is reached, you must clear old trace
requests and their information before initiating new connection traces.
To delete PNNI connection trace information and results that are stored in system VRAM, use the
following command in the privileged EXEC mode:
Command Purpose
show atm pnni trace info Displays the PNNI connection trace
configuration.
Command Purpose
clear atm pnni trace connection Deletes the PNNI connection trace output
stored in VRAM.