Filter
Top Products
25-15
ATM Switch Router Software Configuration Guide
OL-7396-01
Chapter 25 Configuring ATM Router Module Interfaces
Configuring LECs on ATM Router Module Interfaces (Catalyst8540 MSR)
Router 2 Ethernet Interface
Router2# configure terminal
Router2(config)# interface ethernet 9/0/0
Router2(config-if)# bridge-group 1
Router2(config-if)# end
Router2#
Router 2 Bridge Interface
Router2# configure terminal
Router2(config)# interface BVI1
Router2(config-if)# ip address 130.2.3.4 255.255.255.0
Router2(config-if)# exit
Router2(config)# bridge 1 protocol ieee
Router2(config)# bridge 1 route ip
Router2(config)# bridge irb
Router2(config)# end
Router2#
For more information on configuring bridging, refer to the Layer 3 Software Configuration Guide.
Configuring LECs and 1483 PVCs on Enhanced ATM Router Module Interfaces
The following example shows how to configure LECs and 1483 PVCs on enhanced ATM router module
interfaces. Figure 25-6 shows an example of LECs and 1483 PVCs on enhanced ATM router module
interfaces.
Figure 25-6 Example Network for LECs and 1483 PVCs on Enhanced ATM Router Module Interfaces
Router 1 ATM Interface
Router1# configure terminal
Router1(config)# interface atm 2/0
Router1(config-if)# ip address 1.0.0.1 255.0.0.0
Router1(config-if)# atm pvc 1 0 5 qsaal
Router1(config-if)# atm pvc 2 0 16 ilmi
Router1(config-if)# lane client ethernet happy
Router1(config-if)# end
Router1#
ATM Switch Router ATM Router Module Interface
Switch# configure terminal
Switch(config)# interface atm 2/0/0.1 multipoint
Switch(config-if)# ip address 1.0.0.2 255.0.0.0
Switch(config-if)# lane client ethernet happy
Switch(config)# interface atm 2/0/0.2 multipoint
Switch(config-if)# ip address 2.0.0.1 255.0.0.0
Switch(config-subif)# map-group net1011
Switch(config-subif)# atm pvc 2 101 interface atm 3/0/0 0 101 encap aal5snap
Switch(config-subif)# exit
Router 1 Router 2
Catalyst 8540 MSR
ATM router module
Interface ATM 2/0/0
ATM 2/0
ATM 3/0
ATM 3/0/0
105161