Filter
Top Products
25-46
ATM Switch Router Software Configuration Guide
OL-7396-01
Chapter 25 Configuring ATM Router Module Interfaces
Configuring VC Bundling with IP and ATM QoS
The following example configures eight PVCs as members of a VC bundle named Connection to
Switch2.
Switch(config)# interface atm 9/0/0.1 multipoint
Switch(config-subif)# description Connection to Switch2
Switch(config-subif)# ip address 3.0.0.1 255.0.0.0
Switch(config-subif)# bundle cisco
Switch(config-if-atm-bundle)# protocol ip inarp
Switch(config-if-atm-bundle)# oam-bundle manage broadcast
Switch(config-if-atm-bundle)# pvc-bundle 2 200 pd on wrr-weight 2 rx-cttr 301 tx-cttr 301 interface atm
0/0/0.1 2 300
Switch(config-if-atm-member)# precedence 3, 5-7
Switch(config-if-atm-member)# pvc-bundle 2 201 pd on wrr-weight 2 rx-cttr 302 tx-cttr 302 interface atm
0/0/0.1 2 301
Switch(config-if-atm-member)# precedence 4
Switch(config-if-atm-member)# pvc-bundle 2 202 pd on wrr-weight 2 rx-cttr 303 tx-cttr 303 interface atm
0/0/0.1 2 302
Switch(config-if-atm-member)# precedence 2
Switch(config-if-atm-member)# pvc-bundle 2 203 pd on interface atm 0/0/0.1 2 303
Switch(config-if-atm-member)# exit
Switch(config-if-atm-bundle)#
Step 3
Switch(config-subif)# bundle name
Switch(config-if-atm-bundle)#
Creates the VC bundle changes to VC bundle
configuration mode.
Step 4
Switch(config-if-atm-bundle)# protocol {ip-address | ip
ip-address | ipx ipx-address | inarp} [[no]
broadcast]
Configures the VC bundle protocol.
Step 5
Switch(config-if-atm-bundle)# oam-bundle manage
frequency-seconds
Enables end-to-end F5 OAM loopback cell
generation and OAM management for all VCs in the
VC bundle.
Step 6
Switch(config-if-atm-bundle)# pvc-bundle vpi vci interface
atm card/subcard/port vpi vci [upc {tag | drop | pass}] [pd
{on | off | use-cttr}] [rx-cttr rx-row] [tx-cttr tx-row]
[wrr-weight value]
Switch(config-if-atm-member)#
Configures the VC bundle member and changes to
VC bundle member configuration mode.
Step 7
Switch(config-if-atm-member)# precedence {other | range} Configures the precedence level associated with the
VC bundle member.
Step 8
Switch(config-if-atm-member)# bump {implicit | explicit
precedence-level | traffic}
Configures the bumping rules (switching if a VC
fails) for a specific VC bundle member.
Step 9
Switch(config-if-atm-member)# protect {group | vc} Configures the VC to belong to a protected group or
to be individually protected.
Step 10
Switch(config-if-atm-member)# exit
Switch(config-if-atm-bundle)#
Exits back to VC bundle configuration mode to
configure another PVC in the bundle.
Command Purpose