Filter
Top Products
17-7
ATM Switch Router Software Configuration Guide
OL-7396-01
Chapter 17 Configuring Signalling Features
Configuring E.164 Addresses
To configure an E.164 address on a per-interface basis, perform the following steps, beginning in global
configuration mode:
Example
The following example shows how to configure the E.164 address 7654321 on ATM interface 0/0/1:
Switch(config)# interface atm 0/0/1
Switch(config-if)# atm e164 address 7654321
Displaying the E.164 Address Association to Interface Configuration
To display the E.164 configuration, use the following EXEC command:
Example
The following example shows how to display the E.164 address configuration for ATM interface 0/0/1:
Switch# show atm interface atm 0/0/1
Interface: ATM0/0/1 Port-type: oc3suni
IF Status: UP Admin Status: up
Auto-config: enabled AutoCfgState: completed
IF-Side: Network IF-type: NNI
Uni-type: not applicable Uni-version: not applicable
Max-VPI-bits: 8 Max-VCI-bits: 14
Max-VP: 255 Max-VC: 16383
ConfMaxSvpcVpi: 255 CurrMaxSvpcVpi: 255
ConfMaxSvccVpi: 255 CurrMaxSvccVpi: 255
ConfMinSvccVci: 35 CurrMinSvccVci: 35
Svc Upc Intent: pass Signalling: Enabled
ATM Address for Soft VC: 47.0091.8100.0000.0041.0b0a.1081.4000.0c80.0010.00
ATM E164 Address: 7654321
<information deleted>
When the E.164 gateway feature is configured, the switch first attempts to make a connection using the
E.164 gateway feature. If that connection fails, the switch attempts to make the connection using the
E.164 address autoconversion feature, described in the following section.
Command Purpose
Step 1
Switch(config)# interface atm card/subcard/port
Switch(config-if)#
Selects an interface port.
Step 2
Switch(config-if)# atm e164 address
e164-address
Associates the E.164 address to the interface.
Command Purpose
show atm interface atm card/subcard/port Shows the E.164 address configuration on a
per-port basis.