Filter
Top Products
4-6
ATM Switch Router Software Configuration Guide
OL-7396-01
Chapter4 Configuring System Management Functions
System Management Tasks
Configuring Scheduler Attributes
To control the maximum amount of time that can elapse without running the lowest-priority system
processes, use the following global configuration commands:
Configuring Services
To configure miscellaneous system services, use the following global configuration commands:
Command Purpose
scheduler allocate msecs Configures the guaranteed CPU time for
processes, in milliseconds. The minimum
interval is 500 ms; the maximum value is
6000 ms.
scheduler process-watchdog {hang |
normal | reload | terminate}
Configures scheduler process-watchdog
action for looping processes.
scheduler interval msecs Specifies maximum time in milliseconds that
can elapse without running system processes.
Command Purpose
service alignment Configures alignment correction and logging.
service compress-config Compresses the configuration file.
service config Loads config TFTP files.
service disable-ip-fast-frag Disables IP particle-based fast fragmentation.
service exec-callback Enables EXEC callback.
service exec-wait Configures a delay of the start-up of the EXEC on noisy
lines.
service finger Allows Finger protocol requests (defined in RFC 742) from
the network server.
service
hide-telnet-addresses
Hides destination addresses in Telnet command.
service linenumber Enables a line number banner for each EXEC.
service nagle Enables the Nagle congestion control algorithm.
service old-slip-prompts Allows old scripts to operate with SLIP/PPP.
service pad Enables Packet Assembler Dissembler commands.
service
password-encryption
Enables encrypt passwords.
service prompt Enables a mode-specific prompt.
service slave-log Enables log capability on slave IPs.
service tcp-keepalives {in |
out}
Configures keepalive packets on idle network connections.
service tcp-small-servers Enables small TCP servers (for example, ECHO).