Filter
Top Products
19-21
ATM Switch Router Software Configuration Guide
OL-7396-01
Chapter 19 Configuring Circuit Emulation Services
Configuring T1/E1 Structured (n x 64) Circuit Emulation Services
Name Status Status Status Reg State State State
------------- -------- ------------ -------- ------------ --------- --------
ATM0/0/1 DOWN down waiting n/a Idle n/a
ATM0/0/5 DOWN shutdown waiting n/a Idle n/a
ATM0/0/6 DOWN shutdown waiting n/a Idle n/a
ATM0/0/7 DOWN shutdown waiting n/a Idle n/a
ATM0/1/0 DOWN shutdown waiting n/a Idle n/a
ATM0/1/1 DOWN shutdown waiting n/a Idle n/a
ATM0/1/2 DOWN shutdown waiting n/a Idle n/a
ATM0/1/3 UP up done UpAndNormal Active n/a
ATM0/1/7 DOWN down waiting n/a Idle n/a
ATM1/0/0 DOWN down waiting n/a Idle n/a
ATM1/0/1 DOWN down waiting n/a Idle n/a
ATM1/0/2 DOWN down waiting n/a Idle n/a
ATM1/0/3 UP up done UpAndNormal Active n/a
ATM1/1/0 UP up done UpAndNormal Active n/a
ATM1/1/1 DOWN down waiting n/a Idle n/a
ATM1/1/2 DOWN down waiting n/a Idle n/a
ATM1/1/3 DOWN down waiting n/a Idle n/a
ATM2/0/0 UP up n/a UpAndNormal Idle n/a
ATM-P3/0/3 UP up waiting n/a Idle n/a
ATM3/1/0 DOWN down waiting n/a Idle n/a
ATM3/1/1 UP up done UpAndNormal Active 2way_in
ATM3/1/2 DOWN down waiting n/a Idle n/a
ATM3/1/3 DOWN down waiting n/a Idle n/a
ATM-P4/0/0 UP up waiting n/a Idle n/a
CESwitch# configure terminal
CESwitch(config)# interface cbr 3/0/0
CESwitch(config-if)# shutdown
CESwitch(config-if)# ces aal1 service structured
CESwitch(config-if)# ces dsx1 clock source network-derived
CESwitch(config-if)# ces dsx1 framing esf
CESwitch(config-if)# ces dsx1 linecode b8zs
CESwitch(config-if)# ces circuit 1 timeslots 1-3,7
CESwitch(config-if)# ces circuit 1 circuit-name CBR-PVC-A
CESwitch(config-if)# ces pvc 1 interface atm 0/1/3 vpi 0 vci 100
CESwitch(config-if)# no shutdown
Note If you do not specify the circuit name and logical name parameters in the command line, the system
automatically assigns a unique default name in the form CBRx/y/z:# for the circuit being configured. For
example, the default name for this particular circuit is CBR3/0/0:1. For structured CES, the circuit
number sequence always begins at 1 for each port in a CES module.
The virtual path identifier/virtual channel identifier (VPI/VCI) values shown in the example (vpi 0
vci 100) are for demonstration purposes only. The service provider you select gives you a virtual path
for your data, but you must decide which VCI number to assign to the circuit.