Filter
Top Products
17-21
ATM Switch Router Software Configuration Guide
OL-7396-01
Chapter 17 Configuring Signalling Features
Multipoint-to-Point Funnel Signalling
Examples
Use the show atm status command to display the number of active funnels, point-to-point and
point-to-multipoint setup messages. An example of the show atm status command output follows:
Switch# show atm status
NUMBER OF INSTALLED CONNECTIONS: (P2P=Point to Point, P2MP=Point to MultiPoint,
MP2P=Multipoint to Point)
Type PVCs SoftPVCs SVCs TVCs PVPs SoftPVPs SVPs Total
P2P 26 0 0 0 2 0 0 28
P2MP 1 0 0 0 0 0 0 1
MP2P 0 0 1 0 0 0 0 1
TOTAL INSTALLED CONNECTIONS = 30
PER-INTERFACE STATUS SUMMARY AT 13:34:48 UTC Thu Jan 29 1998:
Interface IF Admin Auto-Cfg ILMI Addr SSCOP Hello
Name Status Status Status Reg State State State
------------- -------- ------------ -------- ------------ --------- --------
ATM0/0/0 UP up done UpAndNormal Active 2way_in
ATM0/0/1 DOWN down waiting n/a Idle n/a
ATM0/0/2 UP up done UpAndNormal Active 2way_in
ATM0/0/3 UP up done UpAndNormal Active 2way_in
ATM0/0/3.55 UP up waiting WaitDevType Idle n/a
ATM0/0/3.60 UP up waiting WaitDevType Idle n/a
ATM0/0/3.65 UP up waiting WaitDevType Idle n/a
ATM0/1/0 UP up n/a UpAndNormal Active n/a
ATM0/1/1 UP up done UpAndNormal Active n/a
ATM0/1/2 DOWN shutdown waiting n/a Idle n/a
ATM0/1/3 DOWN down waiting n/a Idle n/a
Use the show atm vc cast mp2p command to display the status of the multipoint-to-point messages on
the specific interfaces. An example of the show atm vc cast mp2p command output follows:
Switch# show atm vc cast mp2p
Interface VPI VCI Type X-Interface X-VPI X-VCI Encap Status
ATM0/1/0 0 40 SVC ATM0/1/1 0 35 UP
ATM0/1/1 0 36 UP
ATM0/1/1 0 35 SVC ATM0/1/0 0 40 UP
ATM0/1/1 0 36 SVC ATM0/1/0 0 40 UP