Filter
Top Products
11-44
ATM Switch Router Software Configuration Guide
OL-7396-01
Chapter 11 Configuring ATM Routing and PNNI
Advanced PNNI Configuration
To specify an aggregation token value, perform these steps, beginning in global configuration mode:
Example
The following example shows how to configure an aggregation token on ATM interface 1/0/1:
Switch(config)# interface atm 1/0/1
Switch(config-if)# atm pnni aggregation-token 100
Displaying the Aggregation Token Configuration
To display the aggregation token configuration, use the following EXEC command:
Examples
The following example shows the aggregation token value for all interfaces using the show atm pnni
interface EXEC command:
NewYork.BldB.T3# show atm pnni interface
PNNI Interface(s) for local-node 1 (level=56):
Local Port Type RCC Hello St Deriv Agg Remote Port Rem Node(No./Name)
~~~~~~~~~~~~~ ~~~~~ ~~~ ~~~~~~~~ ~~~~~~~~~~ ~~~~~~~~~~~~~ ~~~~~~~~~~~~~~~~~~
ATM0/0/2 Phy UP comm_out 2 ATM0/0/3 - SanFran.BldA.T4
ATM0/1/2 Phy DN down 35
ATM0/1/3 Phy UP 2way_in 0 ATM1/1/3 10 NewYork.BldB.T1
NewYork.BldB.T3#
The following example shows the aggregation token value details for a specific interface using the
show atm pnni interface EXEC command with the detail keyword:
NewYork.BldB.T3# show atm pnni interface atm 0/0/2 detail
PNNI Interface(s) for local-node 1 (level=56):
Port ATM0/0/2 RCC is up , Hello state common_out with node SanFran.BldA.T4
Next hello occurs in 4 seconds, Dead timer fires in 72 seconds
CBR : AW 5040 MCR 155519 ACR 147743 CTD 154 CDV 138 CLR0 10 CLR01 10
VBR-RT : AW 5040 MCR 155519 ACR 155519 CTD 707 CDV 691 CLR0 8 CLR01 8
VBR-NRT: AW 5040 MCR 155519 ACR 155519 CLR0 8 CLR01 8
ABR : AW 5040 MCR 155519 ACR 0
UBR : AW 5040 MCR 155519
Aggregation Token: configured 0 , derived 2, remote 2
Tx ULIA seq# 1, Rx ULIA seq# 1, Tx NHL seq# 1, Rx NHL seq# 2
Remote node ID 72:160:47.009144556677223310111266.00603E7B2001.00
Remote node address 47.009144556677223310111266.00603E7B2001.01
Remote port ID ATM0/0/3 (80003000) (0)
Command Purpose
Step 1
Switch(config)# interface atm card/subcard/port
Switch(config-if)#
Specifies the ATM interface.
Step 2
Switch(config-if)# atm pnni aggregation-token
value
Enters a value for the aggregation-token on the
ATM interface.
Command Purpose
show atm pnni interface atm
card/subcard/port [detail]
Displays the interface PNNI configuration.