Filter
Top Products
21-18
ATM Switch Router Software Configuration Guide
OL-7396-01
Chapter 21 Configuring IMA Port Adapter Interfaces
Configuring IMA Group Parameters
Examples
The following example shows how to configure the test pattern 8 to transmit over link 3 of
IMA group 0/0/ima1:
SwitchA(config)# interface atm 0/0/ima1
SwitchA(config-if)# ima test link 3 pattern 8
The following example shows how to stop the test on IMA group 0/0/ima1:
SwitchA(config)# interface atm 0/0/ima1
SwitchA(config-if)# no ima test
Displaying the IMA Group Test Pattern Configuration
To display the IMA group test pattern configuration, use the following EXEC command:
Example
The following example shows the IMA group test pattern configuration:
SwitchA# show ima interface
ATM0/0/ima1 is up
Group Index = 4
State: NearEnd = operational, FarEnd = operational
FailureStatus = noFailure
IMA Group Current Configuration:
MinNumTxLinks = 1 MinNumRxLinks = 1
DiffDelayMax = 25 FrameLength = 128
NeTxClkMode = common(ctc) CTC_Reference_Link = ATM0/0/3
TestLink = 3 TestPattern = 8
TestProcStatus = operating GTSM change timestamp = 990427143950
IMA Link Information:
Link Physical Status NearEnd Rx Status Test Status
----- --------------- ----------------- ---------------
ATM0/0/2 up active operating
ATM0/0/3 up active operating
Step 2
Switch(config-if)# ima test [link link-value]
[pattern pattern-value]
Specifies the specific link and pattern or test
pattern only for the IMA group.
Step 3
Switch(config-if)# no ima test Stops the test on the IMA group.
Command Purpose
Command Purpose
show ima interface [atm card/subcard/imagroup
[detailed]]
Displays IMA group interface configuration
and status.