Filter
Top Products
25-45
ATM Switch Router Software Configuration Guide
OL-7396-01
Chapter 25 Configuring ATM Router Module Interfaces
Configuring VC Bundling with IP and ATM QoS
Switch1#
The following command confirms that the connection traffic table rows were created as needed for the
ATM connection between Switch 1 and Switch 2:
Switch1# show atm connection-traffic-table
Row Service-category pcr scr/mcr mbs cdvt pd
.
.
.
301 vbr-nrt 2000 1640-0 none none off
302 vbr-nrt 1500 1200-0 none none off
303 vbr-nrt 400 350-0 none none off
500 cbr 10000 none off
501 cbr 10000 none off
The following commands configure the hierarchical tunnel service categories needed for the ATM
connection between Switch 1 and Switch 2:
Switch1(config)# interface atm 0/1/1
Switch1(config-if)# description OC-3 at Switch1
Switch1(config-if)# atm pvp 10 hierarchical rx-cttr 500 tx-cttr 500
Switch1(config-if)# atm pvp 11 hierarchical rx-cttr 501 tx-cttr 501
Switch1(config-if)# end
Switch1#
The following command confirms that the hierarchical tunnel service was configured on the ATM
connection between Switch 1 and Switch 2:
Switch1#show run interface atm 0/1/1
Building configuration...
Current configuration : 193 bytes
!
interface ATM0/1/1
description OC-3 at Switch1
no ip address
no ip route-cache cef
atm pvp 10 hierarchical rx-cttr 500 tx-cttr 500
atm pvp 11 hierarchical rx-cttr 501 tx-cttr 501
end
Switch1#
Creating PVCs and Configuring VC Bundle on Enhanced ATM Router Module
This section describes creating the PVCs and configuring the VC bundle on the enhanced ATM router
module.
To configure the VC bundle, use the following commands, beginning in global configuration mode:
Command Purpose
Step 1
Switch(config)# interface atm
card/subcard/port.subinterface# multipoint
Switch(config-subif)#
Creates the ATM Router Module point-to-multipoint
subinterface and enters subinterface mode.
Step 2
Switch(config-subif)# ip address ip-address mask Provides a protocol address and subnet mask for the
client on this subinterface.