Cisco Systems OL-7396-01 Network Router User Manual


 
3-30
ATM Switch Router Software Configuration Guide
OL-7396-01
Chapter 3 Initially Configuring the ATM Switch Router
Testing the Configuration
Confirming the ATM Interface Configuration
Use the show atm interface command to confirm the ATM interfaces are configured correctly:
Switch# show atm interface atm 1/0/0
Interface: ATM1/0/0 Port-type: oc3suni
IF Status: UP Admin Status: up
Auto-config: disabled AutoCfgState: not applicable
IF-Side: Network IF-type: NNI
Uni-type: not applicable Uni-version: not applicable
Max-VPI-bits: 8 Max-VCI-bits: 14
Max-VP: 255 Max-VC: 16383
ConfMaxSvpcVpi: 255 CurrMaxSvpcVpi: 255
ConfMaxSvccVpi: 255 CurrMaxSvccVpi: 255
ConfMinSvccVci: 35 CurrMinSvccVci: 35
Svc Upc Intent: pass Signalling: Enabled
ATM Address for Soft VC: 47.0091.8100.0000.00e0.4fac.b401.4000.0c80.8000.00
Configured virtual links:
PVCLs SoftVCLs SVCLs TVCLs PVPLs SoftVPLs SVPLs Total-Cfgd Inst-Conns
4 0 0 0 1 0 0 5 3
Logical ports(VP-tunnels): 1
Input cells: 263109 Output cells: 268993
5 minute input rate: 0 bits/sec, 0 cells/sec
5 minute output rate: 1000 bits/sec, 2 cells/sec
Input AAL5 pkts: 171788, Output AAL5 pkts: 174718, AAL5 crc errors: 0
Confirming the Interface Status
Use the show atm status command to confirm the status of ATM interfaces:
Switch# show atm status
NUMBER OF INSTALLED CONNECTIONS: (P2P=Point to Point, P2MP=Point to MultiPoint)
Type PVCs SoftPVCs SVCs PVPs SoftPVPs SVPs Total
P2P 30 0 0 1 1 0 32
P2MP 0 0 0 1 0 0 1
TOTAL INSTALLED CONNECTIONS = 33
PER-INTERFACE STATUS SUMMARY AT 16:07:59 UTC Wed Nov 5 1997:
Interface IF Admin Auto-Cfg ILMI Addr SSCOP Hello
Name Status Status Status Reg State State State
------------- -------- ------------ -------- ------------ --------- --------
ATM1/1/0 DOWN down waiting n/a Idle n/a
ATM1/1/1 DOWN down waiting n/a Idle n/a
ATM1/1/2 DOWN down waiting n/a Idle n/a
ATM1/1/3 DOWN down waiting n/a Idle n/a
ATM0 UP up n/a UpAndNormal Idle n/a
ATM3/0/0 UP up n/a UpAndNormal Active LoopErr
ATM3/0/0.99 UP up waiting WaitDevType Idle n/a
ATM3/0/1 UP up done UpAndNormal Active LoopErr
ATM3/0/2 UP up n/a UpAndNormal Active LoopErr
ATM3/0/3 UP up done UpAndNormal Active LoopErr
ATM3/1/0 UP up done UpAndNormal Active LoopErr
ATM3/1/1 UP up done UpAndNormal Active LoopErr
ATM3/1/2 UP up done UpAndNormal Active LoopErr
ATM3/1/3 UP up done UpAndNormal Active LoopErr
<information deleted>