Filter
Top Products
14-23
ATM Switch Router Software Configuration Guide
OL-7396-01
Chapter 14 Configuring LAN Emulation
LANE Configuration Examples
Token Ring Example (Catalyst 8510 MSR and LightStream 1010)
In this Token Ring example, the Cisco 7505 router contains the LECS, LES, BUS, and an LEC. The ATM
switch router and Catalyst 5500 Fast Ethernet switch each contain an LEC for the emulated LAN. This
example uses all LANE default settings. For example, it does not explicitly set ATM addresses for the
different LANE components that are co-located on the router. Membership in this emulated LAN is not
restricted.
Router 1
router1# show lane default-atm-addresses
interface ATM3/0:
LANE Client: 47.00918100000000603E7B2001.00000C407572.**
LANE Server: 47.00918100000000603E7B2001.00000C407573.**
LANE Bus: 47.00918100000000603E7B2001.00000C407574.**
LANE Config Server: 47.00918100000000603E7B2001.00000C407575.00
note: ** is the subinterface number byte in hex
ATM Switch
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# atm lecs-address-default 47.00918100000000603E7B2001.00000C407575.00
Switch(config)# end
Switch#
Router 1
router1# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
router1(config)# lane database eng_dbase
router1(lane-config-database)# name eng_elan server-atm-address
47.00918100000000603E7B2001.00000C407573.01
router1(lane-config-database)# name eng_elan local-seg-id 2048
router1(lane-config-database)# default-name eng_elan
router1(lane-config-database)# exit
router1(config)# interface atm0
router1(config-if)# atm pvc 1 0 5 qsaal
router1(config-if)# atm pvc 2 0 16 ilmi
router1(config-if)# lane config auto-config-atm-address
router1(config-if)# lane config database eng_dbase
router1(config-if)#
%LANE-5-UPDOWN: ATM0 database example1: LE Config Server (LECS) changed state to up
router1(config-if)# interface atm3/0.1
router1(config-subif)# ip address 172.16.0.1 255.255.0.0
router1(config-subif)# lane server-bus tokenring eng_elan
router1(config-subif)# lane client tokenring eng_elan
router1(config-subif)#
%LANE-5-UPDOWN: ATM0.1 elan eng: LE Client changed state to up
router1(config-subif)# end
router1#