Filter
Top Products
20-5
ATM Switch Router Software Configuration Guide
OL-7396-01
Chapter 20 Configuring Frame Relay to ATM Interworking Port Adapter Interfaces
Configuring the Channelized DS3 Frame Relay Port Adapter
Displaying the CDS3 Frame Relay Port Adapter Controller Information
To display the controller configuration, use one of the following EXEC commands:
Example
The following example displays the configuration, status, and statistics of T1 line number 1 on controller
0/1/0:
Switch# show controllers t3 0/1/0:1 tabular
T3 0/1/0:1 is up.
PAM state is Up
1CT3 H/W Version: 1.7
1CT3 F/W Version: 2.7
T3 0/1/0 T1 1
Transmitter is sending LOF Indication (RAI).
Receiver has loss of frame.
Framing is ESF, Line Code is B8ZS, Clock Source is line.
INTERVAL LCV PCV CSS SELS LES DM ES BES SES UAS SS
12:43-12:51 0 0 0 0 0 0 0 0 0 434 0
12:28-12:43 0 0 0 0 0 0 0 0 0 900 0
12:13-12:28 0 0 0 0 0 0 0 0 0 900 0
11:58-12:13 0 0 0 0 0 0 0 0 0 900 0
11:43-11:58 0 0 0 0 0 0 0 0 0 900 0
11:28-11:43 0 0 0 0 0 0 0 0 0 900 0
11:13-11:28 0 0 0 0 0 0 0 0 0 900 0
10:58-11:13 0 0 0 0 0 0 0 0 0 900 0
Total 0 0 0 0 0 0 0 0 0 6300 0
Deleting a Channel Group on the CDS3
This section describes two ways to delete a channel group on the CDS3 after it has been configured.
If you want to delete individual channel groups without shutting down the controller, use method one.
If you want to delete several channels groups on a controller, use method two. However, if you
use method two, you must first shut down the controller, which shuts down all channel groups on
the controller.
Method One
Perform the following steps, beginning in global configuration mode:
Command Purpose
show controllers t3
card/subcard/port[:t1-line] [brief | tabular]
Displays T3 and T1 configuration.
Command Purpose
Step 1
Switch(config)# interface serial
card/subcard/port:cgn
Selects the Frame Relay serial port and
channel group number to be deleted.
Step 2
Switch(config-if)# shutdown Shuts down the serial interface.