Filter
Top Products
114
C
HAPTER
6: M
ANAGING
N
ETWORK
I
NTERFACES
Display
Auto-configuration
Status
Display the auto-configuration status for the specified port of the
CoreBuilder 9000 ATM Enterprise Switch. Auto-configuration determines,
by negotiation, the User-Network Interface (UNI) parameters for the
specified port. The configuration options are enabled (auto-configured)
or disabled (not auto-configured). For more information about
auto-configuration, see “Auto-Configuration” on page 62 in the
Operations Guide.
Command Actions
Command Result
Example
Enter:
1 1 8 2 1 3.1.2
The following message is displayed:
Auto-Configuration is ENABLED.
Enter the menu sequence:
(1) SYS: Platform Configuration
(1) SET: Switch Setup
(8) IME: ILMI Setup
(2) AUC: Auto-Configuration Setup
(1) GET: Get Auto-Configuration
ON/OFF Status
Enter a parameter at the prompt
Parameter Format or Range
Port ID <slot.group.port>
Direct access sequence:
1 1 8 2 1
[parameters]
System action taken:
The auto-configuration status for the specified port is
displayed.
System message display:
Auto-Configuration is
<ENABLED/DISABLED>.