Filter
Top Products
400
C
HAPTER
11: C
ONFIGURING
AND
M
ANAGING
PNNI
Set Cache State
Set the DTL cache state to ENABLED/DISABLED. The default cache state is
ENABLED. If the cache is disabled, it is not refreshed and calls are not
added to it. This means that for each incoming call, a new path will be
recalculated. A change to the DTL cache state takes place immediately.
Command Actions
Command Result
Example
Enter:
1 1 9 4 6 2 1
The following message is displayed:
PNNI cache ENABLED.
Press ENTER to continue...
Enter menu sequence:
(1) SYS: Platform Configuration
(1) SET: Switch setup
(9) PNI: PNNI Setup
(4) CFP: Configure PNNI
(6) SCR: Set Route Cache (UBR)
Configuration
(2) SCS: Set Cache State
Enter a parameter at the prompt
Parameter
Format or Range
Cache state
0
- enable
1
- disable
Direct access sequence:
1 1 9 4 6 2
System action taken:
The DTL cache state is updated to disabled/enabled.
System message display:
PNNI cache DISABLED/ENABLED.