Filter
Top Products
398
C
HAPTER
11: C
ONFIGURING
AND
M
ANAGING
PNNI
Set Scope Mapping
Table to Defaults
Resets all the parameters of the scope mapping table to their default
values. A change to the scope mapping table parameters takes place
after the next reboot.
Command Actions
Command Result
Example
Enter:
1 1 9 4 4 5 3
The following prompt is displayed:
Set PNNI Scope Mapping Table to defaults (y/n)
Enter 'y' or 'Y', all other input keeps the old values
Y
The following message is displayed:
PNNI Scope Mapping Table is set to default values
Press ENTER to continue...
Enter menu sequence:
(1) SYS: Platform Configuration
(1) SET: Switch setup
(9) PNI: PNNI Setup
(4) CFP: Configure PNNI
(4) ICF: Interface Configuration
(5) SMT: Scope Mapping Table
Configuration
(3) SST: Set Scope Mapping Table
to defaults
Enter a parameter at the prompt
Parameter
Format or Range
Confirm reset
y
or
n
Direct access sequence:
1 1 9 4 4 5 3
System action taken:
The scope mapping table parameters are reset to their
default values as defined in the PNNI specification
af-pnni-0080_000.
System message display:
PNNI Scope Mapping Table is set to
default values