Filter
Top Products
ILMI Setup
115
Update
Auto-configuration
Status
Update the Auto-configuration Status for the specified port in the
CoreBuilder 9000 ATM Enterprise Switch. Enable the Auto-configuration
Status only if both ATM Switch Fabric Modules have an
auto-configuration capability. For more information about
auto-configuration, see “Auto-Configuration” on page 62 in the
Operations Guide.
Command Actions
Command Result
Example
Enter:
1 1 8 2 2
3.1.2
1
The following message is displayed:
Auto-Configuration is set to ENABLED.
The auto-configuration status of port 3.1.2 is enabled.
Enter the menu sequence:
(1) SYS: Platform Configuration
(1) SET: Switch Setup
(8) IME: ILMI Setup
(2) AUC: Auto-Configuration Setup
(2) SET: Set Auto-Configuration
ON/OFF Status
Enter a parameter at the prompt
Parameter Format or Range
Port ID <slot.group.port>
Auto-configuration
enable/disable
0
to disable auto-configuration
1
to enable auto-configuration
Direct access sequence:
1 1 8 2 2
[parameters]
System action taken:
The Auto-configuration Status is updated for the
selected port.
System message display:
Auto-Configuration is set to
<ENABLED/DISABLED>.