Filter
Top Products
358
C
HAPTER
11: C
ONFIGURING
AND
M
ANAGING
PNNI
Set Hello Holddown
Timer
Sets the Hello holddown timer value. The Hello holddown timer value is
the value (expressed in milliseconds) used by the specified node to limit
the rate at which it sends Hello packets. A change to the Hello holddown
timer value takes place after the next reboot. For more information on
Hello packets, see “Information Exchange in PNNI” on page 189 in the
Operations Guide.
Command Actions
Command Result
Example
Enter:
1 1 9 4 3 4 1 5
The following message is displayed:
Default Value is 10 (1 sec), new value is 5
Press ENTER to continue...
Enter menu sequence:
(1) SYS: Platform Configuration
(1) SET: Switch setup
(9) PNI: PNNI Setup
(4) CFP: Configure PNNI
(3) NCF: Node Configuration
(4) TIM: Timers
(2) HHD: Hello Holddown Timer
Enter a parameter at the prompt
Parameter
Format or Range
interval 1 - 30000 milliseconds
Direct access sequence:
1 1 9 4 3 4 2
[parameters]
System action taken:
The Hello holddown timer values is displayed and is
updated to its new value.
System message display:
Default value is <x>, new value is <y>