Filter
Top Products
350
C
HAPTER
11: C
ONFIGURING
AND
M
ANAGING
PNNI
Set Node ID
Updates the ID of the PNNI node to a new address. A change to the node
lD takes place after the administrative status is set to UP or after the next
reboot. For more information, see “Set Node Administrative Status to
UP” on page 337.
There are several PNNI operations in the LMA that can only be performed
when the node administrative status is set to DOWN, and that take effect
immediately after the status is reset to UP. These include updating the
ATM address, updating the PNNI node id and updating the node level.
Command Actions
Command Result
Enter menu sequence:
(1) SYS: Platform Configuration
(1) SET: Switch setup
(9) PNI: PNNI Setup
(4) CFP: Configure PNNI
(3) NCF: Node Configuration
(3) CHR: Characteristics
(4) NID: Node ID
(3) SID: Set Node ID
Enter a parameter at the prompt
Parameter
Format or Range
node id 20 bytes
Direct access sequence:
1 1 9 4 3 3 4 3
System action taken:
The current PNNI node id is set to the new address.
System message display:
New Node ID was set. Node Id: