Filter
Top Products
Configuring PNNI Nodes
341
Set Node Level
Updates the current node level. The node level is the hierarchy level of the
peer group to which it belongs. For more information, see “Organizing a
Network Hierarchy” on page 183 in the Operations Guide. A change to
the node level takes place after the next reboot.
It is important not to split ELANs between groups when constructing the
network hierarchy.
There are several PNNI operations in the LMA that can only be performed
when the node administrative status is set to DOWN, and that take effect
immediately after the status is reset to UP. These include updating the
ATM address, updating the PNNI node id and updating the node level.For
more information, see “Set Node Administrative Status to DOWN” on
page 338.
Command Actions
Command Result
Example
Enter:
1 1 9 4 3 3 1 2 80
The following message is 7displayed:
Node 1 of 1. Current Node Level is set to 80.
The node level of node 1 is set to 80.
Enter menu sequence:
(1) SYS: Platform Configuration
(1) SET: Switch setup
(9) PNI: PNNI Setup
(4) CFP: Configure PNNI
(3) NCF: Node Configuration
(3) CHR: Characteristics
(1) LEV: Level
(2) SNL: Set Node Level
Enter a parameter at the prompt
Parameter
Format or Range
PNNI node level 0 to 104
Direct access sequence:
1 1 9 4 3 3 1 2
System action taken:
The current node level is updated.
System message display:
Node <x> of <y>. Current node level is
set to <n>.