Filter
Top Products
360
C
HAPTER
11: C
ONFIGURING
AND
M
ANAGING
PNNI
Set Hello Inactivity
Factor
Sets the Hello inactivity factor. The Hello inactivity factor is
the amount of
time (expressed in Hello intervals) after which the sending node will consider
a link to its neighbor down, if the neighbor does not respond. For more
information on Hello intervals, see
“Set Hello Interval” on page 359
.
A
change to the Hello inactivity factor takes place after the next reboot.
Command Actions
Command Result
Example
Enter:
1 1 9 4 3 4 4 10
The following message is displayed:
Default Value is 5, new value is 10
Press ENTER to continue...
Enter menu sequence:
(1) SYS: Platform Configuration
(1) SET: Switch setup
(9) PNI: PNNI Setup
(4) CFP: Configure PNNI
(3) NCF: Node Configuration
(4) TIM: Timers
(4) INF: Hello Inactivity Factor
Enter a parameter at the prompt
Parameter
Format or Range
interval 1 - 100 Hello intervals
Direct access sequence:
1 1 9 4 3 4 4
[parameters]
System action taken:
The Hello inactivity factor is displayed and is updated
to its new value.
System message display:
Default value is <x>, new value is <y>