Filter
Top Products
ILMI Setup
119
Update LEC/LECS
Communication
Channel
Update the LECS-via-ILMI parameter for the specified port in the
CoreBuilder 9000 ATM Enterprise Switch. If this parameter is enabled, the
LEC communicates on the channel VPI/VCI = (0/16) with the ILMI MIB. It
submits an inquiry to obtain the LECS address. If this parameter is
disabled, the LEC connects to the LECS using the well-known address or
via the preconfigured LECS address in the LEC.
Command Actions
Command Result
Example
Enter:
1 1 8 3 2
3.1.2
1
The following message is displayed:
LECS via ILMI is set to ENABLED.
The LECS-via-ILMI status of port 3.1.2 is enabled.
Enter the menu sequence:
(1) SYS: Platform Configuration
(1) SET: Switch Setup
(8) IME: ILMI Setup
(4) MIB: ILMI MIB View Setup
(2) SET: Set LECS via ILMI
ON/OFF Status
Enter a parameter at the prompt
Parameter Format or Range
Port ID <slot.group.port>
LECS-via-ILMI
enable/disable
0
to disable LECS-via-ILMI
1
to enable LECS-via-ILMI
Direct access sequence:
1 1 8 3 2
[parameters]
System action taken:
The LECS-via-ILMI status is updated for the selected
port.
System message display:
LECS via ILMI is set to
<ENABLED/DISABLED>.