Filter
Top Products
156
C
HAPTER
7: C
ONFIGURING
V
IRTUAL
C
HANNELS
Create PVC — Quick
Setup
Set up PVC using the default for parameters not explicitly set. Default
values for Cell Loss Level, Priority, and Cell Loss Priority are used. (See
Table 23.) The same limits as full PVC call setup apply. For more
information, see “Permanent Virtual Channels” on page 87 in the
Operations Guide.
Command Actions
Command Result
Example
Enter:
3 4 1 3 p2p 5.1.1 0 37 5.1.2 0 381
The following message is displayed:
A new PVC was created with call number: 9.
Enter the menu sequence:
(3) CON: Connections
(4) S&C: Setup of Connections and ATM
Addresses
(1) PVC: PVCs Setup
(3) CRP: Create PVC call
Enter a parameter at the prompt
Parameter Format or Range
Call type
P2P
for point-to-point PVC
P2M
for point-to-multipoint PVC
First port number <slot.group.port>
First port VPI See “Display PVC VPI/VCI Limits” on page 151 for
VPI/VCI limits.
First port VCI See “Display PVC VPI/VCI Limits” on page 151 for
VPI/VCI limits.
Second port number <slot.group.port>
Second port VPI See “Display PVC VPI/VCI Limits” on page 151 for
VPI/VCI limits.
Second port VCI See “Display PVC VPI/VCI Limits” on page 151 for
VPI/VCI limits.
Direct access sequence:
3 4 1 1 3
[parameters]
System action taken:
A PVC with the required parameters is created.
System message display:
A new PVC was created with call number:
<n>