Filter
Top Products
Setting the Port Network Connection Type
75
Update Port Network
Connection Type
Update the network connection type (EIISP, UNI, IISP or PNNI) for a
specified port of the CoreBuilder 9000 ATM Enterprise Switch.
Command Actions
Command Result
Example
Enter:
1 1 3 4 3.1.2 1
The following message is displayed:
This operation will release all SVC connections of the
specified port(s)!
Are you sure (Y/N)?
Enter
y
to confirm. The following message is displayed:
UNI type was set.
The network connection type for port 3.1.2 is updated to UNI.
Enter the menu sequence:
(1) SYS: Platform Configuration
(1) SET: Switch Setup
(3) NNI: NNI Setup
(4) SIF: NNI Set Interface Type
Enter a parameter at the prompt
Parameter Format or Range
Port number slot.group.port (0.0 for all ports)
NNI interface type
0
to set network connection type to EIISP
1
to set network connection type to UNI
2
to set network connection type to IISP
3
to set network connection type to PNNI
Direct access sequence:
1 1 3 4
[parameters]
System action taken:
The network connection type for the specified port is
updated.
System message display:
EISP/UNI/IISP/PNNI type was set.