Filter
Top Products
Setting the Timers
361
Set PTSE Refresh
Interval
Sets the PTSE refresh interval value. The PTSE refresh interval is the
amount of time (in seconds) that passes before the next
PTSE
is flooded to all
the nodes in the current peer group.
A change to the PTSE refresh interval
value takes place after the next reboot.
Command Actions
Command Result
Example
Enter:
1 1 9 4 3 4 5 1500
The following message is displayed:
Default Value is 1800, new value is 1500
Press ENTER to continue...
Enter menu sequence:
(1) SYS: Platform Configuration
(1) SET: Switch setup
(9) PNI: PNNI Setup
(4) CFP: Configure PNNI
(3) NCF: Node Configuration
(4) TIM: Timers
(5) PRI: PTSE Refresh Interval
Enter a parameter at the prompt
Parameter
Format or Range
interval 1 - 60000 seconds
Direct access sequence:
1 1 9 4 3 4 5
[parameters]
System action taken:
The Hello inactivity factor is displayed and is updated
to its new value.
System message display:
Default value is <x>, new value is <y>