Filter
Top Products
Setting Up for Management
57
Update IP Address
Update the IP address of the CoreBuilder 9000 ATM Enterprise Switch.
The default factory IP address is
0.0.0.0.
The IP address is changed after the next reboot.
Command Actions
Command Result
Example
Enter:
1 1 2 1 2 100.0.2.2
The following message is displayed:
IP address was successfully set for next reboot.
The IP address is updated to 100.0.2.2 and takes effect after the next
reboot.
CAUTION:
Make sure to change the factory default IP address to a valid
IP address that matches your network IP addresses.
Enter the menu sequence:
(1) SYS: Platform configuration
(1) SET: Switch setup
(2) MNG: Management setup
(1) SIP: IP Setup
(2) SIP: Set IP Address
Enter a parameter at the prompt
Parameter Format or Range
IP Address Valid IP address
Direct access sequence:
1 1 2 1 2
[parameters]
System action taken:
The IP address is updated.
System message display:
IP address was successfully set for
next reboot.