Filter
Top Products
96
C
HAPTER
5: C
ONFIGURING
THE
P
LATFORM
Set Port Frame Mode
Set the interface mode of the selected port as SDH or SONET and save to
flash memory. You are prompted to specify a port and a mode.
Command Actions
Command Result
CAUTION
: When setting the port frame mode on one of the ports of an
OC-3c or 155 Mbps-over-UTP5 card, all four ports are automatically
updated, even if only one port was selected.
Example
Enter:
1 5 3
5.1.1
0
The following messages are displayed:
The following settings will take place:
Changing port <5.1.1> setting from SONET mode to SDH mode.
Changing port <5.1.2> setting from SONET mode to SDH mode.
Changing port <5.1.3> setting from SONET mode to SDH mode.
Changing port <5.1.4> setting from SONET mode to SDH mode.
Do you really want to do these changes? (Y/N)?
y
Enter
y
to confirm. The following message is displayed:
Setting port frame mode has completed successfully.
The selected port(s) are set and saved.
Enter the menu sequence:
(1) SYS: Platform Configuration
(5) IFC: Interface Cards
(3) SFM: Set Port Frame Mode
Enter a parameter at the prompt
Parameter Format or Range
Port ID slot.group.port (0.0 - For all)
Frame Mode
0
- SDH
1
- SONET
Direct access sequence:
1 5 3
[parameters]
System action taken:
The frame mode of the selected port on the interface
module is set and saved.
System message display:
Setting port frame mode has completed
successfully.