Filter
Top Products
Signaling Setup
179
Reset Signaling
Configuration
Reset the signaling configuration parameters for the CoreBuilder 9000
ATM Enterprise Switch to their factory default settings. All signaling
timers are set to default as UNI and the UNI version is set to 3.0. The reset
takes effect immediately.
Command Actions
Command Result
Example
Enter:
1 1 4 7
The following prompt appears:
Do you really want to reset config? (Y/N) Y
Enter
Y
to confirm,
N
to cancel.
Signaling Configuration was set to defaults.
The signaling configuration parameters are set to their factory values.
Enter the menu sequence:
(1) SYS: Platform configuration
(1) SET: Switch setup
(4) SIG: Signaling Setup
(7) SIG: Set signaling configuration
to factory defaults
Enter a parameter at the prompt
Parameter Format or Range
Confirm Reset
Y
or
N
Direct access sequence:
1 1 4 7
System action taken:
The signaling configuration parameters are reset to
their factory default values.
System message display:
Signaling Configuration was set to
defaults.